How to Use the Pattern Resizer Tool
1. Enter Stitch Count
Input your chart's grid width and height - these never change.
2. Pick Original Fabric
Select the fabric count your pattern was designed for (often 14ct Aida).
3. Pick New Fabric
Choose the count you want to switch to and instantly see the new finished size and percentage change.
About the Pattern Resizer Tool
The Pattern Resizer Tool shows exactly what happens to your finished piece when you switch fabric counts. A cross stitch chart is just a grid of squares - its physical size is set entirely by the fabric you stitch it on.
Switch from 14-count Aida to 18-count and the same chart shrinks about 22%; switch to 11-count and it grows about 27%. Stitching 28-count Linen over 2 leaves the size identical to 14-count Aida (28 ÷ 2 = 14 stitches per inch). This tool computes the new dimensions and the exact percentage change so you can fit frames, hoops, and expectations.
Resize Calculation Formulas
Finished Size (in) = Stitches ÷ Effective Fabric Count
Effective Count = Count (Aida) or Count ÷ 2 (Linen over 2)
Size Change % = (New Size ÷ Original Size - 1) × 100
Resize & Conversion Tips
- 14ct → 11ct: +27% larger. Great for kids or low-vision stitching.
- 14ct → 16ct: -12.5%. A classic fit for standard frames.
- 14ct → 18ct: -22%. Compact, painterly full-coverage look.
- 14ct → 28ct Linen over 2: identical size, softer texture.
Frequently Asked Questions
Does switching fabric count change my chart?
No - you stitch the identical chart and stitch count. Only the physical fabric grid density changes.
How much smaller is 18-count than 14-count?
About 22% smaller in both dimensions (14 ÷ 18 = 0.78).
Is 28-count Linen over 2 the same as 14-count Aida?
Yes - 28 ÷ 2 = 14 stitches per inch, so finished dimensions match exactly.
Do I need less floss on a higher count?
Slightly - smaller stitches use a little less thread, but strand count remains the dominant factor.
How do I fit a pattern to a specific frame?
Choose a fabric count whose finished size matches your frame opening, leaving 2-3 inches of border for mounting.